> ## Documentation Index
> Fetch the complete documentation index at: https://docs.heyniblet.com/llms.txt
> Use this file to discover all available pages before exploring further.

# Set up a Niblet display

> Install firmware, connect the display locally, and verify its 64×32 panel.

## What you need

* A supported Niblet controller and 64×32 HUB75 panel
* The supplied 5 V power source and a data-capable USB-C cable
* A 2.4 GHz Wi-Fi network
* The Niblet app or web dashboard

<Steps>
  <Step title="Install the matching firmware">
    Open [the browser installer](https://www.heyniblet.com/install) in desktop Chrome or Edge, connect the display directly over USB, and select the image for your board.
  </Step>

  <Step title="Create the display record">
    Sign in, choose **Add device**, select **New Niblet display**, and assign a room. Niblet creates a one-time enrollment bundle before the setup client leaves your normal network.
  </Step>

  <Step title="Connect locally">
    Join the temporary setup network shown by the device. The setup client sends Wi-Fi credentials and the private device feed directly to the display.
  </Step>

  <Step title="Wait for cloud confirmation">
    Keep USB power connected until the app confirms that the display reached Niblet Cloud.
  </Step>

  <Step title="Inspect the panel">
    Run the red, green, and blue pixel test. Stop if pixels or complete bands are missing; panel and cable faults should not be hidden in software.
  </Step>
</Steps>

<Warning>
  Wi-Fi credentials stay between the setup client and the display. Do not paste them into chat, MCP arguments, support messages, or Cloud configuration.
</Warning>

## If setup is interrupted

Power-cycle once and reopen setup. A new device should return to provisioning mode; a configured device should retain its last verified configuration. If a USB firmware write was interrupted, reconnect in bootloader mode and reinstall instead of repeatedly disconnecting power during a write.