Skip to main content

​
What you need

  • A supported Niblet controller and 64×32 HUB75 panel
  • The supplied 5 V power source and a data-capable USB-C cable
  • A 2.4 GHz Wi-Fi network
  • The Niblet app or web dashboard
1

Install the matching firmware

Open the browser installer in desktop Chrome or Edge, connect the display directly over USB, and select the image for your board.
2

Create the display record

Sign in, choose Add device, select New Niblet display, and assign a room. Niblet creates a one-time enrollment bundle before the setup client leaves your normal network.
3

Connect locally

Join the temporary setup network shown by the device. The setup client sends Wi-Fi credentials and the private device feed directly to the display.
4

Wait for cloud confirmation

Keep USB power connected until the app confirms that the display reached Niblet Cloud.
5

Inspect the panel

Run the red, green, and blue pixel test. Stop if pixels or complete bands are missing; panel and cable faults should not be hidden in software.
Wi-Fi credentials stay between the setup client and the display. Do not paste them into chat, MCP arguments, support messages, or Cloud configuration.

​
If setup is interrupted

Power-cycle once and reopen setup. A new device should return to provisioning mode; a configured device should retain its last verified configuration. If a USB firmware write was interrupted, reconnect in bootloader mode and reinstall instead of repeatedly disconnecting power during a write.